ABTI-GM1 General Motors Class II Bluetooth Interface Installation Manual

June 19, 2011 by · Leave a Comment
Filed under: GM 

The ABTI-GM1 is designed to allow full integration of Motorola’s IHF-1000 Bluetooth HandsFree kit (Sold separately) with GM Class 2 vehicles listed inside. The kit will allow users to listen to phone calls through their car stereo. The currently playing radio source will be automatically muted, and the phone volume may be controlled by the radio. OnStar operation is unaffected.
Read more

BX1682 Baseplate Installation Instructions

June 19, 2011 by · Leave a Comment
Filed under: Other 

Installation Instructions
Vehicle Weight: The weight of this vehicle is near the Class III, 5,000 lb rating limitations. Some models, depending on options, may well exceed this 5,000 lb rating. Be sure to confirm the weight of your individual vehicle before towing. As of 1999 the Aventa® II is now rated 10,000 lbs. and either the Aventa® II or the Aventa® LX tow bar must be used for these applications.
Read more

Heated Windshield Washer Module Short Circuit Permanently Disable and Remove Module

June 19, 2011 by · Leave a Comment
Filed under: GM 

General Motors has decided that a defect, which relates to motor vehicle safety, exists in certain 2006-2009 model year Buick Lucerne; Cadillac DTS; HUMMER H2; 2008-2009 model year Buick Enclave; Cadillac CTS; 2007-2009 model year Cadillac Escalade, Escalade ESV, Escalade EXT; Chevrolet Avalanche, Silverado, Suburban, Tahoe; GMC Acadia, Sierra, Yukon, Yukon XL; Saturn OUTLOOK; and 2009 model year Chevrolet Traverse vehicles equipped with a heated washer fluid system (RPO XA7/CHW). A recall was implemented on some vehicles in 2008 to add a fuse to the HWFS control circuit Read more

BC BRONCO Rear Disk Brakes Installation

June 18, 2011 by · Leave a Comment
Filed under: Cadillac 

Basic kit includes:
NOTE: All other parts to complete the rear disk brake install may be purchased at a full service auto parts store or may be purchased directly from BC Broncos as needed or as a complete kit.
2 – BC Broncos caliper hanger bracket (right/left)
NOTE: The caliper hanger brackets come in either “big bearing” or “small bearing” configurations.
Read more

2004 Cadillac CTS-V Exhaust System Installation

June 17, 2011 by · Leave a Comment
Filed under: Cadillac 

Prior to installation, be sure your vehicle is parked on a level surface, and the exhaust system is cool. For safety purposes and ease of installation, we urge you to take your vehicle to a qualified service center or muffler installer that employs the use of a lift.
Read more

Cadillac HS Vortex Meter

June 17, 2011 by · Leave a Comment
Filed under: Cadillac 

The Cadillac® Vortex Meter is a rate and totalizing meter which is capable of measuring liquid, steam and gas. Due to it’s rugged design it is particularly suitable for direct steam measurement. In any steam system the Cadillac® Vortex Meter is the number one technology choice due to Cadillac®’s accuracy, linearity, reliability and rangeability.
Read more

BMW iBus Relay Unit Installation Manual

May 31, 2011 by · Leave a Comment
Filed under: BMW 

What this unit actually does?
This unit helps you to switch on or off devices, control signals and so on…
How it works?
Unit has three single pole double throw relays with terminal-type connectors: one input and two outputs (normally-opened and normally-closed). By pressing programmed button on steering wheel or board monitor, corresponding relay will be triggered and as result your device will be switched on or off (or some signal controlled).
Is my car compatible with the iBus Relay Unit?
Read more

TEC BMW E39 5-Series Cup Holder Installation

May 31, 2011 by · Leave a Comment
Filed under: BMW 

As the owner of one of the world’s premier touring automobiles, your ‘5’er’ has the performance and luxury to ensure an ultimate driving experience. Our cup holder is specifically designed to provide the convenience, utility and appearance suited to your BMW.
Read more

2009 BMW K1300R/S Akrapovic Slip-On Exhaust System

May 31, 2011 by · Leave a Comment
Filed under: BMW 

REMOVAL OF STOCK EXHAUST SYSTEM:
1. Put the motorcycle on a side stand, we recommend a racing stand. Make sure, that surface is solid and flat.
2. Unscrew the bolts of the heat shield from the link pipe and remove the heat shield.
3. Unscrew the bolt from the metal clamp at the muffler – link pipe joint (Figure 3, 4). Unscrew the bolt from the muffler metal clamp and remove the muffler.
Read more

Audi A6 C5 Air Conditioner Output Diagnostic Test Mode (DTM)

April 30, 2011 by · Leave a Comment
Filed under: Audi 

Initiating output DTM
- Star engine (vehicles up to model year 2001).
- Switch ignition on or start engine (vehicles from model year 2002).
Notes: The engine should not be running, if the actuation of “A/C Compressor Regulator Valve -N280-” or “A/C clutch -N25-” is being checked on vehicles from model year 2002. With engine running the A/C Control Head -E87- does not Read more

Next Page »