1993 Mercedes Benz 300E 4Matic (124 Chassis) Fuse Block Location
Download this manual for find the fuse block location for 1993 Mercedes Benz 300E 4Matic (124 Chassis) L6-2960cc 3.0L SOHC (103) car.
Vehicle Level – Power and Ground Distribution – Fuse Block – Locations
Fuse and Relay Block Identification and Location
Read more
2002-2006 Honda CR-V Subwoofer Kit Installation Instructions
The subwoofer can not be installed with an under-seat CD changer.
Installation the Subwoofer to 2002-2006 CRV:
1. Make sure you have the anti-theft code for the radio, then write down the radio station presets.
2. Disconnect the negative cable from the battery.
3. Remove the two screws that fasten the bottom of the center panel.
4. Pull the center panel out toward you to release the six clips, unplug the vehicle connector from the hazard switch, and remove the center panel. Be careful care not to damage the clips.
Read more
BMW Z3 Model 68 Subwoofer Installation Instructions
Read these instructions from start to finish twice before you even go near the car! Professional installation is recommended for those who are unfamiliar with car audio. These instructions assume you have already installed your new amplifier.
Remove old enclosure:
1. Carefully remove the subwoofer enclosure cover by first lifting the rear edge of the cover and then lifting entire cover straight up. The cover should lift out with minimal effort, but may require some additional effort to release the rear snaps. Take your time and be careful when removing the sub lid! The easiest thing to do is to insert a flat, metal, handled-tool like a stiff putty knife and carefully pry each side up from the back. NOTE: If you have the storage compartment, you may find it easier to temporarily remove the storage compartment lid while performing the install.
Read more
1999.5-2001 Audi A4 (B5) HID conversion installation instructions
1. Take the kit out of the box and lay everything out. You can install either the ballasts or bulbs first but typically it is easier to install the bulbs first.
2. There are 3 T27 torx screws holding the headlight on. The 2 on top are visible in this picture.
3. with the 2 screws removed.
4. The third screw is shown here. A long extension is needed to get to it and an extendable magnet is helpful to retrieve the screw (or bit if it falls).
5. Disconnect the headlight and turn signal connectors and remove the headlight by pulling it toward the outside of the car and toward you.
Read more
BMW E46 Subwoofer System by BSW Installation Guide: d110.e46c for BMW 3 Series
We’re going to proceed as follows:
1. Disassembling the trunk
2. Power/ground wire connections
3. Making appropriate wiring connections for audio inputs
4. Installing the subwoofer enclosure
5. Tuning/testing the system
Read more
Nissan Titan King Cab Vehicle Specific Subwoofer Enclosure
The enclosure mounts under rear seat firing down, in Nissan Titan King/Crew Cab trucks.
TOOLS REQUIRED FOR INSTALLATION: Powered Screwdriver 6″ Bit Holder Extension Socket Wrench
INSTALLATION: Follow the steps below
1. Slide front seats to full forward position. This will give you more room to work with.
Read more
1996-1999 Nissan Pathfinder (R50) Automatic to Manual Transmission Conversion Manual
This manual will, in detail, give the information you will need to convert a 4×4 1996-1999 Nissan Pathfinder from an automatic transmission to a manual transmission. Having a manual transmission in your Pathfinder gives you more control, lower gears, and more power than you would have with an automatic. Other benefits include better gas mileage, lower maintenance cost and reduced electronic dependence.
Read more
1999 Protege 1.6L Rattling Noise From Engine
APPLICABLE MODEL(S)/VINS
All 1999 Protege (1.6L) with VINs lower than JM1 BJ222* X0 140057.
All 1999 – 2000 Miata with (1.8L) VINs lower than JM1 NB353* Y0 155947.
DESCRIPTION A rattling noise may be heard from the engine when depressing the clutch or when revving the engine in neutral. In extreme cases, customers may experience noise at all times. This concern can be caused by improperly machined number 4 main cap of cylinder blocks which may result in premature wear of the thrust bearing. Customers having this concern should have their vehicle repaired using the following procedure.
Read more
Audi Gateway 500 with Dual FOT Installation
Installation of GATEWAY 500 unit Dual FOT
For All Audi vehicles: A good location to mount the GATEWAY 500 unit is at the CD Changer behind the glove box. If the vehicle is equipped with the in-dash CD Changer, install the GATEWAY 500 unit behind it. Interfacing in the MOST optical ring should be done as shown in the installation guide.
For All Audi vehicles NOT equipped with a factory CD Changer, the GATEWAY 500 interface shall be integrated into the optical MOST ring at the output of the head unit.
For All Audi vehicles equipped with a factory CD Changer, the GATEWAY 500 interface shall be installed at the factory CD Changer location
Read more
1999-2002 Suzuki Grand Vitara Vehicle Wiring
WIRING INFORMATION 1999 Suzuki Grand Vitara WIRE WIRE COLOR LOCATION 12V CONSTANT WIRE WHITE/GREEN Ignition Harness 12V IGNITION WIRE BLACK/BLUE Ignition Harness SECOND IGNITION WIRE BLUE/BLACK Ignition Harness 12V ACCESSORY WIRE YELLOW/BLACK Ignition Harness SECOND ACCESSORY WIRE BLUE Ignition Harness STARTER WIRE BLACK/RED or BLACK/YELLOW Ignition Harness POWER DOOR LOCK (-) PINK At Door Lock Module Under Dash Right Of Brake Pedal POWER DOOR UNLOCK (-) PINK/GREEN At Door Lock Module Under Dash Right Of Brake Pedal PARKING LIGHTS (+) RED/YELLOW At Black Connector At The Fuse Box DOOR TRIGGER (-) BLACK/RED White Connector At Read more
