2001-2004 Audi A6 4B C5 Single-Frame front bumper HF 7551 Installation Guide
1. Removal of the original bumper:
Remove all screws which hold the bumper. Also remove the screws which hold the alloy bar and remove the bumper with the alloy bar. Remove the alloy bar from the bumper and install it into the new Hofele-Design bumper.
2. Placement of the Hofele-Design front bumper on the car:
Place the new bumper on the car but do not yet bolt it on.
3. Preparation of the bonnet:
Remove the front grill and the rubber strap behind it. Install the front grill (HF 7052-S4 / RS4) in the extension piece.
Read more
2004-05 Chevy Colorado Prerunner Rear Bumper Installation
This kit should only be installed on a vehicle that is in good mechanical condition. Before installing the kit, replace worn or corroded parts. If the vehicle is suspected to have been in a collision or abused, DO NOT install the kit. The components in this kit do not eliminate weaknesses that may exist in the original equipment components.
Read more
350Z GT Aero Front Bumper Installation Manual
This product is meant to fit Nissan 350Z only. Please check the parts before mounting.
- Mounting Procedure
Please follow the manufacturer’s repair manual for proper front bumper cover removal procedure.
（Remove the side bracket from the OEM bumper. ）
(Remove the impact foam from the front of the bumper.）
Install the side bracket onto the GT bumper by reversing the steps used to remove it.
Install the GT bumper using the factory clips and screws to the original locations.
Read more
Audi HomeLink System (Europe) with the transmitter unit in the front bumper
The HomeLink system provides a convenient way to replace up to three remote controls with a single built-in component. This innovative feature learns the radio frequency codes of most current remote controls used to activate garage doors, property gates, security systems, and home or office lighting.
Read more
1993 Taurus/Sable Bumpers Removal and Installation
Bumpers Refer to the following illustrations when performing Removal and Installation procedures on the front and rear bumper assemblies. CAUTION: Never apply excessive heat to bumper surface. Heat could cause distortion of the bumper. CAUTION: When collecting exhaust fumes in service area, never attach a metal collector to the exhaust tail pipe because the heat could damage the bumper.
Read more
2000-04 Audi 2.7T AWE/McNeil Competition Air/Air Intercooler Kit
Congratulations on your purchase of the AWE/McNeil Competition Intercoolers for your 2.7T Audi. Hundreds of hours of design and operational testing were spent to ensure maximum results without compromise. You have truly selected the best performing intercooler kit for the 2.7T engine. While the install is fairly straight forward, please review these instructions carefully before attempting installation. If you do not feel comfortable installing this kit on your own, contact a professional installer in your area. While the car pictured is an Audi S4, installation except where noted is similar on both the A6 and allroad 2.7T.
Read more
2006-2008 Audi A3 Body Exterior Removal and Installation
Keep adhesive surface free of dirt and grease. Only cut back adhesive surface shortly before installation. Do not prime or use a cleaning solution on the adhesive surface. Make sure there is a slight overlap at adhesive joining points, otherwise there may be leaks in these areas.
Bonded panel must be inserted in the vehicle within a maximum of 10 minutes after start of application, otherwise the bonding properties of adhesive sealant material will be impaired. Observe minimum curing times for bonded panel Minimum curing times for bonded sunroof panel.
Read more
2007 Audi Metroproject Quattro Concept
The Audi Metroproject Quattro, has a battery pack in visibly mounted in the boot, and lit in tranquil blue lights with a charge indicator on the side.
The supermini Audi A1 should be available with a turbocharged gas engine, turbocharged diesel engine, ranging in size from 1.2 litres to 2.0 litres. A base model with an 80 horsepower, naturally aspirated 1.4 litre engine is also expected to hit showroom floors.
Read more
2008 Audi R10 TDI Le Mans
The Audi R10 TDI remains unbeaten in the Le Mans 24 Hour race: in its third attempt, the diesel sportscar won the French endurance classic yet again. After the incredible thrill of the 76th edition of the race, Dindo Capello (Italy), Tom Kristensen (Denmark) and Allan McNish (Scotland) triumphed at the wheel of the Audi R10 TDI number 2.
Read more
2007 Audi Q7 4.2 Quattro Premium
With a host of innovative extras included as standard equipment – including Rear View Camera with Acoustic Parking – the Audi Q7 4.2 Premium model delivers superb power, efficiency, and control via a 350 hp 4.2 V8 equipped with FSI® Direct Injection technology, and combined with quattro® all-wheel drive and a 6-speed Tiptronic® transmission. More pictures below…
Read more
