2003 Saturn L300 V6-3.0L VIN R P2119-Throttle Closed Position Performance
The throttle actuator control (TAC) module contains a direct current actuator motor
controlled by the ECM used to move the throttle plate (in either direction) and two throttle
position sensors to determine throttle plate position. The throttle plate is held at a 7% rest
position to a mechanical stop by a constant force return spring. This spring will hold the
throttle plate to the stop when there is no current flowing to the actuator motor. There is
another return spring, which creates constant force on the throttle plate only when the
throttle plate is moved towards the full closed position. The ECM will monitor both the
actuator motor and TP sensors for circuit faults, as well as check to make sure both
springs can return the throttle to the 7% position no matter where the throttle plate
remains.
Read more
1989 Mercedes Benz 420SEL (126 Chassis) Electro-Hydraulic Actuator Operation
The electro-hydraulic actuator is bolted to the side of the fuel distributor. It consists of a
plate valve fastened between two electromagnets.
By varying the electric current to the electro-hydraulic actuator and changing the
strength of the magnets, the plate valve can be moved. The varying position of the plate
valve controls the quantity of fuel allowed into the lower chamber of the fuel distributor,
causing the differential pressure to vary. The operating range is from -50 to +150mA.
Differential pressure will be from 0 bar to about 1.6 bar (24 PSI) less than system
pressure.
Read more
58 mm LT1 NOS Throttle Body for the 1994-97 Chevrolet
These instructions must be read and fully understood before beginning installation. Failure to follow these instructions may result in poor performance, vehicle damage, personal injury, or death. If these instructions are not fully understood, installation should not be attempted.
Read more
2003-07 Dodge Dakota 4.7L PowerAid Throttle Body Spacer
Your PowerAid Throttle Body Spacer was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, please contact AIRAID.
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air intake hose assembly.
3. Remove throttle body air intake box and save bolts.
4. Remove (3) bolts from the throttle body.
Read more
Chrysler Throttle Lever Adapter Kit Catalog #1481 Installation Instructions
The #1481 Chrysler Throttle Lever Kit will allow you to connect Chrysler throttle linkages to the Edelbrock Performer Series Carburetor. Please study these instructions carefully before installing your Throttle Lever Adapter Kit.
Read more
1998–2001 Cadillac Catera Auto Off Traction Control System Kit
The Auto Off TCS Kit was designed for GM vehicles using Traction Control Systems (TCS). After installation, this Auto Off TCS Kit provides the antilock brake system/traction control system with a ‘Turn Off’ signal 10 seconds after the ignition is turned On. This means the vehicle will start up with the TCS turned Off rather than the original turned On state. The Auto Off TCS Kit is very easily installed and does not require any original wiring to be cut. All wiring connections are completed using simple and effective wire taps with connectors.
Read more
87-93 Chevrolet S-10 4.3L TBI PowerAid Throttle Body Spacer Installation
This instructions contains how to installation the PowerAid Throttle Body Spacer for 87-93 Chevrolet S-10 4.3L TBI:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner
3. Using 1/2” socket, remove (3) 5/16’ bolts.
* Please Note: Some units have bolts that are drilled and tapped for air cleaner mounting studs.
4. It is not necessary to remove the fuel lines.
Read more
2008 Cadillac SRX Spacious Luxury
The 2008 Cadillac SRX Crossover is still fresh from the all-new, elegantly handcrafted interior it received in 2007, the 2008 Cadillac SRX crossover adds more luxury and convenience to its acclaimed blend of driving performance, spacious versatility and passenger comfort.
The completely redesigned SRX interior featured a new instrument panel, hand-wrapped upper trim, console , center stack, door trim, wood trim, analog clock and steering wheel, providing a more inviting and luxurious environment. Spaciousness was enhanced with a new center console and a new storage compartment on the passenger side of the instrument panel.
Read more
2008 Cadillac STS V V8 Supercharged
The supercharged 2007 Cadillac STS-V is GM’s most intense expression of Cadillac power and performance. It carries all the sophistication of its STS sibling, yet elevates the performance and luxury attributes of the brand’s V-Series lineup to their fullest extent. The STS-V represents an historic combination of performance technology and hand-crafted elegance.
Read more
2007 Cadillac SLS
GM’s luxury brand, Cadillac has enjoyed remarkable success since its introduction to the China luxury market in 2004. The Cadillac China portfolio, consisting of the CTS sedan, the XLR roadster and the SRX crossover, will now be complimented with the all-new SLS and the Escalade SUV. Based on the STS sport sedan, the SLS has been lengthened by 100mm to add rear seat legroom. The interior is designed to meet specific local needs in this primarily chauffeur-driven luxury segment. Three engine options will be available which include the 2.8L V6, a 3.6L V6 and the top-level Northstar 4.6L V8 with 239kW/320hp. The new SLS will be built at the Shanghai GM plant for the Chinese market.
Read more
