1998 Mercedes Benz SLK 230 L4-2.3L SC Rear Center Console Remove/Install
Removing And Installing Rear Center Console
Removing And Installing Front Center Console
AR68.20-P-2350G Remove/Install Cover on Center Console
Removing And Installing Cover On Center Console
Read more
2006 Mazda MX-5 Squeaking Noise Around Rear Center Console Lid
Some vehicles may exhibit a squeaking noise from around the rear center console lid area when driving on a rough road or turning corners at slow speeds. Torque of the rear center console lid striker screw is insufficient. The tightening process has been revised in production. Customers having this concern should have their vehicle repaired using the following repair procedure.
Read more
2000-2005 Cadillar Deville Inner Front Pillar, Center Pillar and Rear Wheelhouse Sectioning
When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Failure to follow the correct procedure could cause air bag deployment, personal injury or unnecessary SIR system repairs. The full bodyside inner panel comes as a one piece assembly and can be replaced at factory seams after removal of outer panel, roof and glass. Any one of these procedures can be performed separately, or in any combination dependent upon the extent of damage to the vehicle.
Read more
1994–2003 Ford Powerstroke 7.3 liter Vehicle Programming Instructions
The following manual contains information and instructions on the proper use of Evolution. Please read carefully before proceeding to program your vehicle. Note: Read the product disclaimer before programming your vehicle.
TOW Program
This setting is the lowest level setting, but still increases your horsepower and torque
Read more
2005-06 In-Service Vehicle Testing Programme
Carbon Dioxide Emissions and Fuel Consumption. Although there are no mandatory in-use compliance requirements for fuel consumption and Carbon Dioxide (CO2) emissions measurements, these parameters are subject to Conformity of Production requirements for new vehicles. Whilst these requirements do not strictly apply to in-use vehicles, the fuel consumption and CO2 Emissions measurements from this programme have been assessed against the conformity of production requirements to give an indication of whether in-use vehicles differ significantly from the type approval measurements. For CO2, an initial sample of three vehicles is tested and the test statistic defined in directive 80/1268 EEC (as amended) is calculated. By comparing the test statistic with the Pass and Fail decision thresholds a Vehicle model can be determined to Pass, Fail, or require more vehicles to be tested.
Read more
2007 Mini To Produce Sports Activity Vehicle
The new MINI Sports Activity Vehicle (SAV) will be built by Magna Steyr Fahrzeugtechnik in Graz, Austria. The vehicle concept, devised by MINI Design and BMW Group engineers, has been entrusted to Magna Steyr Fahrzeugtechnik for series development and for later production.
The cooperation with Magna Steyr is an efficient way for BMW Group to ensure the planned profitable growth through new model launches set out in the company’s strategic alignment.
Read more
Land Rover LR3 Vehicle Enhancement Program
Land Rover is conducting a vehicle enhancement program on LR3 and Range Rover Sport vehicles. At elevated temperatures the spring return force on the air suspension compressor exhaust valve is insufficient to overcome the friction forces, which can lead to the exhaust valve not closing properly. This results in a leak path in the air suspension system and result in an ‘Air Suspension fault’ message. LR3 and Range Rover Sport vehicles will also have an air suspension warning lamp illuminated. Other vehicle and software enhancements will be performed as part of this combined Service Action.
Read more
Toyota Landcruiser Brake Conversion Light Vehicle Standards
Transport Inspectors: Provides sufficient guidance to ensure familiarity with approved brake system modifications to stated Toyota Landcruiser models. Approved Inspection Stations (AIS): Provides sufficient guidance to ensure familiarity with approved brake system modifications to stated Toyota Landcruiser models for the issue of a Safety Certificate. Approved Persons: Provides sufficient guidance to ensure familiarity with approved brake system modifications to stated Toyota Landcruiser models so as to ensure consistent certification of vehicles. Vehicle owner: Provides guidance on vehicle compliance requirements.
Read more
2004 Prius EV (Electric Vehicle) Button Installation Instructions
These instructions allow you to take advantage of the built-in feature of what is commonly called “EV (electric vehicle) Mode” of your 2004+ Prius. In Japan and European versions of the Toyota Prius the vehicle is sold with an EV Button pre-installed by Toyota. For some reason, in the North American version this button is left off (note: speculation focuses on possible EPA/NHTSB regulations that were unclear as to whether the option to use 2 different ‘fuels’ was legal. Also it has been speculated that the decision came from Toyota, but no clear statement, at this writing, has come from Toyota. The EV button MAY become a dealer option or as a standard feature on future model year Priuses).
Read more
Nissan Titan King Cab Vehicle Specific Subwoofer Enclosure
The enclosure mounts under rear seat firing down, in Nissan Titan King/Crew Cab trucks.
TOOLS REQUIRED FOR INSTALLATION: Powered Screwdriver 6″ Bit Holder Extension Socket Wrench
INSTALLATION: Follow the steps below
1. Slide front seats to full forward position. This will give you more room to work with.
Read more
