2003 Dodge RAM BlueHeat Coolant Heater
Special instructions for this model
Motor vehicle types, motor types and equipment variants, which are not specified in this fitting instruction, were not examined. An installation after this fitting instruction can be however possible.
Read more
Darton LS-1/LS-6 Coolant System Flow Testing
Setup: An unmodified LS-1 Chevrolet engine block and an LS-1 Chevrolet engine block with Darton cylinder liners installed are received from Darton International for flow testing. The engine blocks are mounted on the test stand both with the unmodified water pump then with the Evans water pump. The test stand consists of a 10 horsepower electric motor mounted on a frame. The engine block to be tested is mounted to the frame and a belt from the electric motor drives the Read more
2003 Porshe Boxter S
With a 0-60 time of 5.7 seconds, the Boxster S is quite a quick roadster thanks to the 260bhp on tap from its 3.2 litre engine. And the 2.7 litre standard car doesn’t hang about either, producing 228bhp which in the 5 speed manual version gives a 0-60 time of 6.6 seconds. Originally launched in 1997 with a 2.5 litre engine, Porsche enthusiasts demanded more power, and they got it, but to be honest, every Boxster ever produced is a masterpiece of engineering.
Read more
1997-2003 Buick Regal Engine Compartment Fire Recall Bulletin
General Motors has decided that a defect, which relates to motor vehicle safety, exists in certain 1997-2003 model year Buick Regal and Pontiac Grand Prix, 1998-1999 model year Chevrolet Lumina and Oldsmobile Intrigue, 1998-2003 model year Chevrolet Monte Carlo, and 2000-2003 model year Chevrolet Impala model vehicles, equipped with a 3.8L V6 naturally Read more
2003 Lexus ES300 Timing Belt Removal
This pdf guide you to remove the timing belt for 2003 Lexus ES300
Removal (ES 300)
1. Raise and support vehicle. Remove right side front wheel. Remove right fender apron seal. Remove accessory drive belts. Lower vehicle. Disconnect engine coolant reservoir hose from water outlet. Disconnect ground strap connectors.
2. Remove engine moving control rod and engine mounting bracket No. 2 (right side), located near timing belt cover. Remove generator-to-engine bracket for access to timing belt covers.
Read more
2003 Kia Optima 2.4L Replaced Crankshaft Position (CKP) Sensor
Vehicle Application: 2004 Hyundai Sonata 2.4L, Eng Cfg L4, 2003 Hyundai Santa FE 2.4L, Eng Cfg L4 USA 2004 Hyundai Santa FE 2.4L, Eng Cfg L4 2004 Kia Optima 2.4L, Vin 6, Eng Cfg L4 Customer Concern: There is no spark. Tests/Procedures: 1. At the crank position sensor, check for battery voltage to be present on the Red wire with the key on and cranking. The Black wire should be a good ground and the Blue wire should have 5 volts on it from the computer. One may have to disconnect the crank sensor to check for the 5 volt reference. 2. During crank look for a good 5 volt square wave signal on the Blue wire. 3. Check at the ignition coils for good battery voltage key on and cranking. If there is a loss of voltage during crank check the ignition failsafe relay. 4. Check for any stored engine codes.
Read more
2003-4 Nissan 350z Twin Turbo System Installlation Manual
This installation must only be performed by a competently trained technician possessing the factory manual for this vehicle and all of the tools and knowledge required to safely and successfully complete this specific work. This turbocharger kit has been engineered to provide the highest level of reliability achievable in an aftermarket upgrade and relies heavily on the ability of the installer to achieve this. If Jim Wolf Technology, Inc has not previously trained the installer on this installation, it is recommended that the qualified installer contact JWT before attempting this work.
Installation Steps – Perform the following preparatory work:
- Insure that the fuel tank is less than ― full and that it contains 91 or higher octane gas.
- Safely support the vehicle off the ground for easy access under the car.
- Disconnect the battery ground cable
Read more
2003 Subaru Outback Wiper & Washer Systems
2003 ACCESSORIES & EQUIPMENT Wiper & Washer Systems – Baja, Legacy & Outback REAR WIPER ARM
Removal 1. Raise wiper arm cover (A). 2. Loosen nut to remove wiper arm.
INSTALLATION 1. Install in the reverse order of removal. 2. Operate rear wiper once. 3. Align blade to rear defogger heat wire (A).
Tightening torque: Refer to FRONT WIPER , COMPONENT, General Description.
Read more
2003 Suzuki Aerio AWD L4-2.0L Engine Controls MIL ON/DTC P2025 Set
Engine Controls – MIL ON/DTC P2025 Set Section Title: Engine TSB No. TS 07 12065 Division: Automotive Category: Technical SUBJECT: MIL ON DTC P2025 MODEL(S): AERIO (RH420) YEAR: 2003 CONDITION: In extreme cold climates, the MIL may be ON when the engine is started. The DTC P2025 will be stored in the ECM. CAUSE: ECM Software Logic CORRECTION: Using the appropriate service manual, verify the DTC using the troubleshooting chart. If no cause for the DTC is found, reprogram the ECM by using the instructions listed below. Then clear the DTC from the ECM memory.
Read more
2003-Up Nissan 350Z Edelbrock Nitrous System
The Edelbrock Nissan 350Z Performer EFI Nitrous System (Part Number 71007) is designed for 2003-Later Nissan 350Z vehicles equipped with stock 3.5L engines that utilize the returnless style fuel system. Horsepower and torque increases can vary with equipment upgrades and modifications.
Read more
