1995 Buick Regal V6-231 3.8L VIN L SFI – HVAC Blower Motor
HVAC Blower Motor Noise/Vibration
(Install New Blower Motor Assembly and/or VP Lower Compartment Access Hole Cover)
Models:
1995-96 Buick Regal
1995-96 Oldsmobile Cutlass Supreme
1994-96 Pontiac Grand Prix
Condition
Some owners may comment on noise and/or vibration from the HVAC blower motor.
This noise/vibration may be due to the blower motor being out of balance, or contents
(i.e. tissues, papers, etc.) in the instrument panel (I/P) lower compartment being drawn
into the blower motor assembly through the re-circulation door during MAX A/C mode.
Read more
2001 Lexus GS 300 L6-3.0L (2JZ-GE) – Blower Motor Assembly
REMOVAL
1. REMOVE No.2 UNDER COVER
2. REMOVE BLOWER MOTOR
a. Disconnect the connector.
b. Remove the 3 screws and blower motor.
Read more
2008 Ford Truck Escape 2WD V6-3.0L Blower Motor Resistor Service and Repair
2008 Ford Truck Escape 2WD V6-3.0L Vehicle Level Heating and Air Conditioning Blower Motor Resistor Service and Repair
Removal and Installation
1. Lower the glove compartment.
2. Disconnect the blower motor resistor electrical connector.
3. Remove the 2 blower motor resistor screws.
Read more
1994–1999 Cadillac DeVille Blower Motor Installation Instructions
On 1994 and 1995 models: NOTE the below removal procedures pertain to the OE blower motor that was a two piece set up. Remove the cross tower or cross member brace. Disconnect solenoid purge valve electrical and vacuum connectors. Position components aside for access. Remove solenoid purge valve. Remove 3 center screws and inertia plate from blower motor. Reinstall two screws to prevent motor and housing from separating. Disconnect wiring connector from blower motor. Remove 5 blower mounting screws.
Read more
1994-1997 Cadillac Seville Revised HVAC Blower Motor Installation Procedures
The intent of this bulletin is to provide technicians information regarding the proper installation of the Heating, Ventilation and Air Conditioning (HVAC) Module blower motor (with impeller) assembly.
The current available HVAC Module blower motor for the above listed vehicles can be identified by the three mounting holes (1). The original equipment blower motor had five mounting holes.
In order to avoid confusion and ensure a high level of customer satisfaction, when replacing an HVAC Module blower motor, refer to this bulletin for the appropriate procedure.
Read more
2001-2004 Ford Taurus Water In The Blower Case—Blower Motor
Inspect and seal cowl area and install Rain-Hat Extension Seal. Inspect and replace blower motor and/or blower motor resistor if there is evidence of water/corrosion. Refer to the following Service.
Procedure for details.
SERVICE PROCEDURE
1. Access blower motor and resistor per the Workshop Manual Sections 412-02 and 412-04. Inspect for evidence of water/corrosion. If water/corrosion are found or parts have failed, replace per Workshop Manual (blower motor 1F1Z-19805-AA and resistor F6DZ-19A706-AA).
Read more
1993 BMW 325i (E36) Blower Motor Service with Air Conditioning
Removing and Installing/Replacing Heater and Air Conditioning Fan (M50, S50, M52) Additional work on 2-door model: Remove console for the windshield wiper system. Position windscreen wiper, left, vertically. Pull off rubber part and pry out grill. Remove screws from cable channel. Remove screws on right-hand side and take off holder. Unscrew left-hand screw. Pull out air collector in upwards direction. Note:Air collector will be difficult to pull out. M50, M52 Unclip covers. Unscrew bolts. Remove cover of injection-valve plate. Unclip covers and remove screws. Read more
2008 Chevrolet Cobalt
With a broad range of models, offering a variety of well-equipped and sporty choices, the Chevy Cobalt continues to shine as one of the segment’s most popular cars. The Cobalt enters the 2008 model year on the heels of a successful ’07 model year, which introduced several significant enhancements, including more powerful Ecotec engines. For ’08, the Cobalt builds on that powerful foundation with a streamlined model lineup and more standard safety and convenience equipment.
Read more
2002 Ford Taurus V6-3.0L VIN U – A/C – Erratic/Inoperative Blower Case
Some vehicles built between 5/1/2001 and 12/15/2003 may exhibit water in the
blower case or on the passenger side floor, an inoperative climate control blower
motor, a motor that operates on high speed only, and/or a blower motor resistor
failure.
ACTION
Inspect and seal cowl area and install Rain-Hat Extension Seal. Inspect and
replace blower motor and/or blower motor resistor if there is evidence of
water/corrosion. Refer to the following Service Procedure for details.
SERVICE PROCEDURE
Read more
2002 Ford Taurus Water in the Blower Case
This article supersedes TSB 03-15-06 to update the vehicle model years and build date information.
ISSUE
Some vehicles built between 5/1/2001 and 12/15/2003 may exhibit water in the blower case or on the passenger side floor, an inoperative climate control blower motor, a motor that operates on high speed only, and/or a blower motor resistor
failure.
Read more
