Audi TT 1.8t A.W.E. Tuning DV1 Diverter Valve Installation Instructions
With the DV1 Diverter Valve, we believe you have purchased the finest diverter valve for the money. Follow these instructions, and you’ll have your new A.W.E. Tuning DV1 Diverter Valve installed quickly and easily.
Step 1: Here’s an overview picture of the transverse 1.8T engine found in the Audi TT, VW Golf/Jetta/New Beetle 1.8T. The 225hp TT engine looks a little different, but the install of the A.W.E. Tuning valve is the same procedure. For picture clarity, and ease of install, the decorative engine cover has been removed. Removing the cover is easily done by twisting the “+” shaped fasteners on the cover 90 degrees. They’ll pop up when free, allowing you to grab the cover and lift it up and out of the engine bay. (New Beetle requires removing 2 10mm nuts hidden under trim caps, and then sliding forward and out) We’ve also removed the PCV damper in the following pictures for clarity. You won’t need to remove this item to install the valve.
Read more
Stratmosphere HyperBoost Valve (Audi S4) Installation Instructions
Step 1- Remove motor cover
This is the small triangular cover in the front of the engine where the dipstick is located (figure 1). Just twist the two screws 90 degrees counterclockwise. Then lift up the cover. The cover fits onto a rubber round mount at the point on the “triangle” as well. It’s just pressed on there.
Read more
1995 Audi 90 2.8L V6 – 12-Valve Manufactured Suggested Scheduled Maintenance
For 1997-98 model vehicles, manufacturer recommends belt be replaced at 90,00 miles. For 1996 and earlier
model years, the manufacturer does not recommend a specific scheduled maintenance interval. However, belt
manufacturers suggest the belt be replaced at 60,000 mile intervals.
REMOVAL & INSTALLATION
CAUTION: This application is an interference engine. Do not rotate camshaft or crankshaft when timing belt is removed, or engine damage may occur.
Read more
Nissan Vent Control Valve Replacement Service Bulletin
All Nissan models using Vent Control Valve P/Ns 14935-AM60A / AM60B
SERVICE INFORMATION
When replacing the EVAP canister vent control valve for any reason: Use the one listed in the PARTS INFORMATION section of this bulletin on Page 2. For vent control valve replacement procedure, refer to the appropriate section of the Electronic Service Manual (ESM) if needed. Read more
2000-2001 Audi TT 1.8L Turbo Short Throw Shifter Installation Instructions
This B&M Short Throw Shifter has been designed to work on most 2000-2001 Audi TT 1.8L Turbo models. It has been engineered to greatly reduce shift throw and improve shifter feel. The B&M Short Throw Shifter has been designed to work with the stock knob as well as the B&M Knob. Check the parts and tools lists at the beginning of these instructions for the supplied parts and the tools required to install your B&M Short Throw Shifter. Installation of the B&M Short Throw Shifter can be accomplished by anyone with minimal mechanical experience.
Read more
1996-Up Nissan Evap Vent Control Valve Diagnostics Service Bulletin
If an applied vehicle has one (or more) of the following DTCs stored in Self Diagnosis, use the Service Procedure below to check the operation of the EVAP vent control valve.
IMPORTANT NOTES:
• If DTC(s) other than the ones listed below are found stored in Self Diagnosis, the EVAP vent control valve is NOT the cause of the incident.
• If the EVAP vent control valve passes the tests outlined in the following Service Procedure, the cause of the incident is NOT the EVAP vent control valve.
Read more
2001-2008 Mazda Tribute 3.0L Chamshaft Ticking Noise Service Bulletin
This bulletin supersedes the previous bulletin 01-032/06, issued on 10/12/2006. The APPLICABLE MODEL(S)/ VINS, DESCRIPTION, REPAIR PROCEDURE, and WARRANTY INFORMATION have been revised. Some vehicles equipped with a 3.0L engine may exhibit a ticking noise from the left bank cylinder head while the engine is running at normal operating temperature. Customers having this concern should have their vehicle repaired using the following repair procedure. Use the table below to select the correct repair for the applicable model.
Read more
2008 Audi R10 TDI Le Mans
The Audi R10 TDI remains unbeaten in the Le Mans 24 Hour race: in its third attempt, the diesel sportscar won the French endurance classic yet again. After the incredible thrill of the 76th edition of the race, Dindo Capello (Italy), Tom Kristensen (Denmark) and Allan McNish (Scotland) triumphed at the wheel of the Audi R10 TDI number 2.
Read more
2005 Nissan-Datsun Sentra L4-1.8L Evap Canister Purge Volume Control Solenoid Valve
With CONSULT-II
Check air passage continuity of EVAP canister purge volume control solenoid valve
under the given conditions.
Without CONSULT-II
Check air passage continuity of EVAP canister purge volume control solenoid valve
under the given conditions.
Read more
Crower Valve Train Components
This booklet is a general installation reference guide for Crower valve train components. The information is intended to give you a good basic idea of what building a reliable and powerful performance valve train requires. We’ve tried to eliminate the “surprises” and provide you with solutions to any snags you might encounter. It should help minimize your anxiety when there’s more to a job than you planned on, or when parts don’t fit properly.
Read more
