2008 Chrysler PT Street Cruiser Sunset Boulevard Edition
Chrysler again kicks off the annual Woodward Dream Cruise today with the introduction of its newest special-edition PT Cruiser dedicated to a great American road that is part of Hollywood legend and the inspiration for countless songs, movies and TV shows – Sunset Boulevard in Los Angeles. Announced in conjunction with Detroit’s famed Woodward Dream Cruise, the 2008 Chrysler PT Street Cruiser Sunset Boulevard Edition will be available later this summer as a limited-production version of the 2008 Chrysler PT Cruiser.
Read more
Land Cruiser Disk Brake Conversion
This is the Rear Disk Brake Conversion Bracket used with 1978 MoteCalo Calipers for the Toyota Land Cruiser Model FJ40Series Disks/Rotors used are from a Chevy 6 Lug 4 X 4 Regular Cab Pick-up This is drawn to Full scale. Please verify dimensions on all holes prior to drilling. 4X 3/32″ thick Read more
1991 Toyota MR2, Previa & Land Cruiser Pre-Delivery Service
NEW 1991 PDS REQUIREMENTS (MR2, PREVIA & LAND CRUISER) We are introducing PDS procedures for three new 1991 models introduced in the spring of 1990. Pre-delivery service is more than a procedure – it’s a commitment to Toyota owners that their vehicle will be delivered in perfect condition.
Read more
Vertex Electronic Distributor (2 Wire Unit with Ground)
Old Distributor Removal:
Step 1-Disconnect the coil trigger wire coming from the distributor to the negative (-) side of the ignition coil at the coil terminal. Disconnect the wire supplying current to the positive side (+) of the ignition coil. There may be two wires on this terminal, one from the ballast resistor and one from the starter solenoid. The ballast resistor should have one wire left, the Read more
03-05 Chrysler PT Cruiser Turbo P/N 300-138 Installation
Remove the Factory Air Box Lid
a) Loosen the clamp on the factory intake tube at the air box lid.
b) Unclip the factory air box lid and remove from vehicle.
c) Extract the factory air filter box assembly. (Note: leave the base in place)
d) Unclip and remove the small intake tube attached to the factory air filter box.
e) Replace the factory air filter box in its original place and re-connect the hose it its original location.
Read more
1991 Maintenance Schedule for MR2, Previa & Land Cruiser
For 1991 models, the Toyota owner’s manual offers 3 maintenance sections within the maintenance chapter following the introduction page as follows:
(1) GENERAL MAINTENANCE
This section describes maintenance items which are the owner’s responsibility. (2) SCHEDULE A
This schedule is for those Toyota vehicles which may require more frequent maintenance, due to driving conditions, environment, etc. This was formerly known as the “Severe” schedule. (3) SCHEDULE B
Read more
2003-2004 Chrysler PT Cruiser Short Ram System Installation
You have just purchased the finest Air Induction & Filtration system for your car at any price.
The AEM Short Ram Air Intake System is the result of extensive development on a wide variety of cars. It is the most advanced short pipe air intake system on the market. Each system is specifically engineered for its application. All AEM Short Ram Air Intake Systems deliver maximum performance gains through lightweight, all-aluminum, mandrel-bent tubing that is tuned in both length and diameter. The aluminum will not crack in extended use like plastic. The tube length and diameter are matched for each specific engine to give power over a broad RPM range. Unlike plastic systems that use a continually diverging cross-section, we take advantage of the acoustical energy in the inlet duct to promote cylinder filling during the intake valve-opening event. Every intake is coated with a high-gloss, heat-reducing Zirconia based powder coating. This special blend of powder coating helps reduce heat penetration, which in turn reduces the temperature of the inlet air charge.
Read more
Land Cruiser, Scout/12 Circuit Wire Harness Installation Instructions
You have purchased what we at Painless Performance Products believe to be the most up-to-date and easiest-to-
install automotive wire harness on the market. It is designed for easy installation, even if you have very little electrical experience.
All kits have a built-in-anti-theft feature. Removing the fuse labeled “coil” from the fuse block will prevent the vehicle from starting.
Read more
1989 Volkswagen Cabriolet L4-1781cc Powertrain Management System Diagram
Description: 2-way idle speed boost valve Alternator Auxiliary air regulator Battery Cold start enrichment relay Cold start enrichment vacuum switch Cold start valve Control pressure regulator Fuel enrichment switch Fuel gauge sending unit Fuel injection power supply relay Fuel pump Fuel pump relay Hall generator Hot pulse relay Idle boost control unit Ignition coil Ignition control unit Ignition distributor OXS control unit OXS frequency valve OXS thermoswitch Oxygen sensor Spark plug connectors Spark plugs Starter Thermo time switch Transfer fuel pump Voltage Read more
Chrysler-Dodge Radio Wire Harnesses Installation
If your original radio had a braided strap bolted to the rear of the radio.
TIP: Crimp a ring terminal to the new radios ground wire and insert a bolt through both connectors to connect the ring terminal of the braided ground wire to the ring terminal attached to the new radios ground wire.
If your original radio had a plastic connector containing a single wire plugged into the rear of the radio.
TIP: Crimp a male tab spade to the new radios ground wire. Slide it into the female tab spade connector that had originally snapped into the rear of the factory radio.
Read more
