BMW E39 Euro-spec CELIS Angel Eye Head Light Installation

March 11, 2010 by admin · Leave a Comment
Filed under: BMW, PDF Download 

This DIY covers the install of Euro-spec CELIS (aka Angel Eye or halo) assemblies on a pre-2001 E39 to mimic the newer-style 2001+ E39 head lights. Note that the Euro-spec assemblies do not have the small side parking indicator, which is required for DOT-approval.

Recommended Parts:
Philips Ultinon 6000K Xenon HID bulbs (D2S)
Philips PY21W SilverVision bulbs
Read more

Audi TT Coupe (U.S. Version) Fog Light Modification for Daytime Running Light Operation

April 24, 2010 by admin · Leave a Comment
Filed under: Audi, PDF Download 

The U.S. Version of the Audi TT Coupe (and Roadster) does not come factory equipped with daytime running light capability. Daytime running lights being headlamps or similar, smaller lamps that are on whenever the ignition of the car is on. These lamps then also remain on when the parking lights and the headlights are turned on. I feel daytime running lights add to the safety level and overall appearance of any car. You’re more visible to pedestrians and other motorists and the car looks better in the frontal view. So, the challenge was to determine the best way to add daytime running lights to the TT Coupe. Since the TT is equipped with fog lights that are built in to the headlight cluster the plan was to try to modify the circuitry controlling the fog lights to make them behave like daytime running lights. However, I also needed to retain the normal on/off fog light operation during use of the headlights.
Read more

Identifying the Correct Replacement Head Gasket for Certain Remanufactured Engine

April 22, 2011 by admin · Leave a Comment
Filed under: PDF Download 

On various vehicles when servicing the head gasket on certain Ford remanufactured engines, it is critical to determine the type of remanufactured engine that is being serviced, in order to identify the correct replacement gasket.
Read more

Range Rover Engine Cylinder Head Components

June 27, 2010 by admin · Leave a Comment
Filed under: Land Rover 

1. Rocker cover – right hand 2. Engine oil filler cap 3. Oil filler dust cap seal 4. ’O’ ring – oil filler cap 5. Bolt – rocker cover (4 off; 2 x short, 2 x long) 6. Rocker cover – left hand 7. Gasket – rocker cover 8. Cylinder head – left hand 9. Valve spring cap (16 off) 10. Valve stem oil seals (16 off) 11. Collets (16 pairs) 12. Valve spring (16 off) 13. Valve seat insert (16 off) 14. Exhaust valve (8 off) 15. Inlet valve (8 off) 16. Seal – inlet Read more

07-Up Chevy Tahoe LED Upper Quarter Panel Light

May 23, 2010 by admin · Leave a Comment
Filed under: Chevrolet, PDF Download 

Your new IPCW LED Upper Quarter Panel Lights are quality-made products that will work beautifully on your vehicle. Please refer to the pictures below for installation instructions.
Remove the screws in Figure A with a Phillips screwdriver. Untwist the sockets, then gently slide out the tail light.
After the tail light is removed. remove the screw in Figure B.
Remove the screw in Figure C to remove the Upper Quarter panel.
Gently slide out the stock Upper Quarter Panel.
Read more

Service Light Plus Airbag Reset Tool (10 in 1) Instruction Manual

July 26, 2010 by admin · Leave a Comment
Filed under: PDF Download 

This Service Light & Airbag Reset Tool is an essential tool for resetting of oil service light, service warning light, service mileage, service intervals and airbag on European made vehicles like AUDI, BMW, CITROEN, M. BENZ,MINI, SAAB, SEAT, SKODA,VOLKSWAGEN, VOLVO, etc. It is light, compact and very convenient without using the OEM Scanner to do the job. Once hooked up to the vehicle Data Link Connector (DLC), it can perform the following functions:
Read more

1982-02 General Motors J-2000 Panel-Style Factory Head Unit Provisions

June 10, 2010 by admin · Leave a Comment
Filed under: GM 

For BUICK Century 1982-96 Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (4) screws from the top-inside edge of the dash trim bezel. Remove (5) screws from both sides of the steering column. Remove (3) Phillips screws securing the rocker-switch housing and lift the housing out. Remove the bezel. Remove the hardware securing the factory mounting brackets to the factory head unit. Remove and retain the brackets. Skip to the Installation Instructions for ALL VEHICLES on Page #34.
Read more

Malfunction Indicator Lamp/Check Engine Light

July 13, 2010 by admin · Leave a Comment
Filed under: Other 

If this indicator comes on while driving, there is a problem with your engine or its emission control systems. Even though you may feel no difference in your car’s performance, it can reduce your fuel economy and cause your car to put out excessive emissions. Continued operation may cause serious engine damage.
Read more

Turn off your Check Engine light

July 13, 2010 by admin · Leave a Comment
Filed under: Other 

So your Check Engine light is on, staring at you every day. You know there must be something wrong, but you don’t want to pay to have the problem diagnosed. Don’t worry – we’ve got you covered. With a simple code-reader tool, you can find out what’s wrong and turn the light off. When the Check Engine light is on, it means one or more trouble codes are stored in your vehicle’s computer. Trouble codes tell you that a problem was identified in the engine- management system. Reading the stored trouble codes is the first step in diagnosing the problem.
Code readers are inexpensive and simple to use
Read more

Ford Trunk Light Kit Installation

March 29, 2011 by admin · Leave a Comment
Filed under: Ford 

Installing a trunk light kit on a Ford Crown Victoria or Chevrolet Impala requires different installation instructions for different model years. Please use the instructions that pertain to your make and model of vehicle.
1998 and 1999 Ford Crown Victoria
Use the “Ford Trunk Light Kit ETLK01xx” Installation Instructions.
Read more

Next Page »

?>