2008 ABT Volkswagen Touran
ABT Sportsline launched a new modified version of the Volkswagen Touran . Apart from the obvious visual enhancements the ABT Volkswagen Touran also receives power increases for the two power version of the 1.9 TDI engine and the two power versions of the 2.0 TDI engine.
The power increases for the new ABT Touran are:
1.9 TDI: 130 hp (96 kW) instead of 105 hp (77 kW)
1.9 TDI: 115 hp (85 kW) instead of 90 hp (66 kW)
2.0 TDI: 190 hp (140 kW) instead of 170 hp (125 kW)
The new Abt Touran – a practical, noble and dynamical car
Read more
2001-2004 Subaru Outback Skid Plate Installation Instructions
REMOVAL OF ORIGINAL SPLASH PAN Raise and safely support the vehicle on jack stands or on ramps. Locate and remove the two 12mm bolts at the rear of the factory splash pan. Locate and remove the two 10mm screws from the left and right side of the factory splash pan. These are located up inside the fender. Locate and remove the three remaining 12mm bolts from the front of the factory splash pan. The splash pan has retaining tabs around the three bolt holes from the last step and will require some downward force to remove the splash pan from the vehicle
Read more
Thor Audi A4 Skid Plate Installation Instructions
Now that you have familiarized yourself with the parts of the skid plate and prepared the tools you will need to do the job, you’re ready to get started.
Step #1: Drive your car onto a set of car ramps or jack the car up and place jack stands under the vehicle for safety. Also make sure to apply your emergency brake, (we recommend using both the ramps and the jack stands). Start by removing all of the plastic skid plates using your flat head screw driver. Also you will want to remove the metal bracket that is located just behind your lower sub frame. It is the black metal bracket that attaches to the frame with two 10mm head bolts. The following picture shows this bracket.
Some of the newer A4’s will have an extra plastic piece under your front fender liner that needs to be removed. It is held on with one Torx screw that is located directly in front of the tire in the fender well.
Read more
1996-2001 Audi A4 B5 Panzer Plate Skid Plate Installation Instructions
First-time Install Procedure:
Raise car in the air: Use either ramps and wheel chocks or a jack and a pair of jack stands, or a car lift. Car must be raised on both sides for procedure to work.
Remove old belly pan:
1. Put on safety goggles. Remove old plastic belly pan if you still have one installed on your car. Save all 1/4 turn Dzus screws, if present, in provided zip-loc bag. You will not need these for the install but it’s nice to have spares.
2. Remove rear mount of belly pan, if present, with a 10mm wrench (the one with three receptacles on it.). Remove all three 1/4 turn screw (Dzus) receptacles, if present, and save them as spares in provided zip-loc bag. You might want to degrease them first
Read more
2009 Chevy Cobalt SS 2.0L 4 cyl. Turbo Dyno-Proven Intercooler Piping Installation
Before installing any parts of this system read the instructions thoroughly. If you have any questions regarding installation please contact the dealer you purchased this product from. Installation DOES require some mechanical skills. A qualified mechanic is always recommended. *Do not attempt to install the intake system while the engine is hot. The installation may require removal of radiator fluid line that may be hot.
Injen Technology offers a limited lifetime warranty to the original purchaser against defects in materials and workmanship.
Read more
1999 Chevrolet/GMC ½ ton RTII Undercarriage Mounting Instructions
The mounting procedure outlined below covers CHEVROLET/GMC (1999 and Newer) ½ ton 4 X 4 trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
Read more
2008 1,000,000th Volkswagen Golf
The idea for the dual-clutch gearbox was born in motor-racing. It was picked up by Volkswagen in the 1980s and has since been developed further. When the first Volkswagen DSG went into series production in 2003, it sent shockwaves through professional circles. This innovation provided a previously unknown level of shift comfort. The once clear line between automatic and manual gearboxes had been bridged, and an extraordinary level of driving dynamics achieved.
Read more
2007 Volkswagen Golf New TSI Engine
New TSI with 122 PS: Economical and Powerful consuming six percent less fuel and maximum torque of 200 Nm in reserve at a low 1,500 rpm. Maximum power with minimum fuel consumption – this characteristic has, within a very short period of time, made TSI four-cylinder engines a synonym for a new generation of economical and at the same time sporty Volkswagen engines. Performance specifications: 125 kW / 170 PS and 103 kW / 140 PS. The Golf, Golf Variant, Golf Plus, Jetta and Touran are powered by them. In 2006 and once again in 2007 they were awarded the coveted “Engine of the Year Award”. Now Volkswagen is presenting the third TSI; this one is 90 kW / 122 PS strong and will be introduced to the Golf lineup this year.
Read more
1991 Chevy Truck Blazer Full Size Transfer Case Service & Repair
Manual Shift Transfer Case – Transfer Case Replacement – Transfer Case Component Location
NOTICE: When fasteners are removed, always reinstall them at the same location from which they were removed. If a fastener needs to be replaced, use the correct part number fastener for that application. if the correct part number fastener is not available, a fastener of equal size and strength (or stronger may be used. Fasteners that are not reused, and those requiring thread locking compound will be called out. The correct torque value must be used when installing fasteners that require it. If the above conditions are not followed, parts or system damage could result.
Read more
2008 Hummer H3T Revealed
The Hummer H3T is bigger than a midsize truck and smaller than a full-size truck, creating its own niche in the market. It also is infused with the attributes expected of a HUMMER, including exceptional off-road capability and a premium interior that is as functional as it is comfortable.
“With its unique size and HUMMER traits, the Hummer H3T is ideal for the customer who works hard and plays harder,” said Martin Walsh, HUMMER general manager. “It offers the combination of truck versatility and HUMMER off-road prowess that delivers customers to the trail in style.
Read more
