FISCON Pro Hands free kit Installation Manual for Audi
While developing this product, your personal safety combined with the best operating service, modern design and an up-to-date production technique was especially taken into account. Unfortunately, despite the utmost care injuries and/or damages might occur due to improper installation and/or use. Please read the attached instruction manual completely with great care and keep it! All articles of our production line pass through a 100 % check – for your safety and security. We reserve the right to carry out technical changes which serve the improvement at any time. According to each article and purpose, it is sometimes necessary to check each country’s legal regulations before installing and starting the unit.
Installation instruction
1 – CD device Audi A4 8K, A5 8T, Q7 4L
2 – CD device Audi A6 4F /
2 – AMI Audi A6 4F, A4 8K, A5 8T
3 – Telephone interface (behind the glove box)
4 – Microphone (Interior light)
Audi A4 8K, A5 8T
Loosen the necessary screws of the glove box (Fig. 9 – 11). Disconnect the original wiring of the CD/AMI device (if available).
Remove the cover shown on figure 12. Mount the interface to the back of the glove box by using suitable fastener
Remove the airbag sign by using suitable tools (in order to avoid damages) and loose the screw located behind.
NOTE: Does the vehicle have airbags fitted along the A-column it is essential to wire the loom for the microphone BEHIND the airbag. Wire the loom without putting tension on it. Mount the loom without affecting the airbag in it’s functionality.
Open the storage of the interior light and loose the screw (Fig. 19). Mount the microphone on the original location within the interior light – driver’s side
Audi A6 4F
Loosen the necessary screws of the glove box (Fig. 22, 23). Disconnect the original wiring of the CD/AMI device (if available). Mount the interface to the back of the glove box by using suitable fastener.
2010 A5/S5 Cabriolet Media Information
The introduction of A5 and S5 Cabriolet marks the expansion of the A5 model line and the replacement for the 2009 A4 and S4 Cabriolet nameplates. Featuring an innovative cloth acoustic roof that folds in a class-leading 15 seconds at speeds of up to 30 miles per hour, it is lighter than a retractable hard top and improves driving dynamics, center of gravity, and fuel efficiency as a result. Safety continues to be a top priority for Audi, which offers more models earning “Top Safety Pick” recognition from the Insurance Institute for Highway Safety than any other German luxury car brand.
Read more
Audi A4L Installation Manual
This interface offers RGB, AV inserting onto A4/A5/Q5 panel in a plug-n-play way without cutting wire or using solders. It also offers these functions:
● super Stable,Clear and high-resolution RGB processing for Navigation map display.
● automatic camera switch.
● Optional adjustable reverse guideline display for helping reversing.
● Speed pulse, Reverse, Night lamp signals decoded from the CAN bus for the aftermarket navigation.
Installation location：
Remove the big plastic part shown by the yellow arrow，[No screws, only hooks]， then the total plastic can be taken down, and then the 4 screws can be seen.
Remove the 4 screws, then the panel can be taken down, the interface can be installed behind it.
There is a 10P cable which is carrying the signals, the interface will be inserted onto this cable.
6Pin connector to the Box：
Yellow：Battery 12V，BLACK：GND，
RED：ACC（can generated），
GREEN：REVERSE，
WHITE ： Switch signal[=5V when MODE pressed]。
GREY：Please do not use
