1991-96 Ford Escort Baseplate BX2112 Installation Instructions
Installation of this baseplate requires removing the plastic belly pan. The brackets attached to the vehicle’s frame and the tie down brackets also need to be removed. They will be replaced with the baseplate’s side mounts. The plastic around the tie down brackets will need to be trimmed.
1. Read the General Instruction Sheet included with this baseplate.
2. Under the front corners of the car there is a stamped metal bracket that protrudes down with a slot at the bottom. These are called the tie down brackets. The baseplate mounts to the outside of the tie down brackets and to the center engine support bolts, using ten bolts, eight of which are supplied with the baseplate.
Read more
GRIP Chevy Cobalt Body Kit Installation
All GRIP body kits need to be properly sanded and primed before painting, even if the part arrives pre-primed. Failure to properly prepare parts before painting can result in poor paint finish and adhesion. Please prefit parts before painting! Once a part has been painted or modified in any way it cannot be returned.
1: Look over vehicle before installing the body kit to make note of all attachment points on existing fascia. Since GRIP uses all existing attachment points, it is very important not to harm existing mounting holes and / or fasteners. Some fasteners that are drilled out cannot be reused. It is very important to use special care when removing the reusable fasteners from the panels since they will not be provided by GRIP. GRIP only provides non-reusable fasteners with its kits.
Read more
1996-2001 Audi A4 B5 Panzer Plate Skid Plate Installation Instructions
First-time Install Procedure:
Raise car in the air: Use either ramps and wheel chocks or a jack and a pair of jack stands, or a car lift. Car must be raised on both sides for procedure to work.
Remove old belly pan:
1. Put on safety goggles. Remove old plastic belly pan if you still have one installed on your car. Save all 1/4 turn Dzus screws, if present, in provided zip-loc bag. You will not need these for the install but it’s nice to have spares.
2. Remove rear mount of belly pan, if present, with a 10mm wrench (the one with three receptacles on it.). Remove all three 1/4 turn screw (Dzus) receptacles, if present, and save them as spares in provided zip-loc bag. You might want to degrease them first
Read more
