1999-2001 Honda Accord Radio Replacement
To remove the radio, the center dash panel surrounding the radio must be removed. There are three (3) phillips screws that secure this dash panel to the main dash assembly. However, (1) one of the screws is hidden behind the clock.
The clock unsnaps from the dash panel, but requires a very small flat head screwdriver or similar flat tool. Insert the tool into the side gap between the edge of the clock assembly and the dash panel. GENTLY, pry out that edge of the clock. Insert your fingers into the gap and pull firmly to completely remove the clock from the dash panel. Once the clock has been pulled out, unplug the plastic connector attached to the rear of the clock.
Read more
Audi S4/A4 Boost Gauge Installation
The APR Boost Gauge utilizes a VDO boost gauge contained in a vent-replacement pod. Designed with Pro-E for the best in fit and finish, giving you a factory like look and feel. The gauge itself is a 52mm mechanical VDO gauge giving very accurate and reliable boost and vacuum readings. The Gauge Pod can be installed in anyone of the three center vents. The installation illustrates a center vent installation.
Read more
00-05 Audi 2.7T Engines A.W.E. Tuning DV1 Diverter Valves Installation Instructions
Removal of stock valves:
Removal of the stock diverter valves requires removal of decorative engine cover with the “V6 BITURBO” badging. Lift off the cover after twisting X-shaped plastic fasteners 90 degrees with a flat blade screw driver. Valve replacement is much easier done on a cool engine.
Read more
BMW E46 Subwoofer System by BSW Installation Guide: d110.e46c for BMW 3 Series
We’re going to proceed as follows:
1. Disassembling the trunk
2. Power/ground wire connections
3. Making appropriate wiring connections for audio inputs
4. Installing the subwoofer enclosure
5. Tuning/testing the system
Read more
Audi TT 1.8t A.W.E. Tuning DV1 Diverter Valve Installation Instructions
With the DV1 Diverter Valve, we believe you have purchased the finest diverter valve for the money. Follow these instructions, and you’ll have your new A.W.E. Tuning DV1 Diverter Valve installed quickly and easily.
Step 1: Here’s an overview picture of the transverse 1.8T engine found in the Audi TT, VW Golf/Jetta/New Beetle 1.8T. The 225hp TT engine looks a little different, but the install of the A.W.E. Tuning valve is the same procedure. For picture clarity, and ease of install, the decorative engine cover has been removed. Removing the cover is easily done by twisting the “+” shaped fasteners on the cover 90 degrees. They’ll pop up when free, allowing you to grab the cover and lift it up and out of the engine bay. (New Beetle requires removing 2 10mm nuts hidden under trim caps, and then sliding forward and out) We’ve also removed the PCV damper in the following pictures for clarity. You won’t need to remove this item to install the valve.
Read more
